□ Amazing flux recovery performance
□ Dramatically reduce flux adhesion droop problem
□ Improvement of temperature uniformity by new nozzle
□ All zone uniform oxygen concentration control
□ Easy adjustment of height of labyrinth
□ Environment friendly and low power consumption
□ Shorter setting time change time (high temperature → low temperature)
□ World's best flux collection efficiency
- The design is according to the characteristic of flux and air flow inside the heating chamber Large-scale cooling unit in flux recovery unit. It was equipped as standard (2 units).
□ Reduce the flux dripping problem from the top nozzle
- Entrance side with cooling unit to ensure temperature less then 100°C. To prevent flux stick on heater, a formula cooling unit was installed on the bottom side.
□ New type of nozzle with good hot air circulation
- ETC's unique new type of nozzle with 5 level of wind speed setting, it suitable for various kinds of component.
With uniform heating, it can reduce uneven heating problem, the design
of nozzle for cooling zone is to reduce flux drip.
□ All zones have the same oxygen concentration
- Low consumption due to internal pressure control of ETC's proprietary technology, in order to get the same oxygen concentration in all zones,
OSP of the backside surface pad and through hole copper foil can prevent from oxidation.
□ Labyrinth height adjustment unit
- Adjustment of the height of the labyrinth according to the height of the parts, usage and consumption of nitrogen will be improve efficiency with the height or low labyrinth
□ Alternate function cooling unit for all heating zones (option setting)
- When changing the temperature setting of each zone from high temperature to low temperature, utilizing cooling unit from flux recovery unit into heating unit, the temperature setup change time is greatly changed from high to low temperature.
|Start up Power||Max. 31.4kW||Max. 37.9kW||Max. 37.3kW||Max 45.1kW||Max. 43.1kW||Max. 52.4kW|
|Normal Power||Approx. 10.7kW||Approx. 11.5kW||Approx. 11.3kW||Approx. 13.7kW||Approx. 13.1kW||Approx. 15.9kW|
|N2 Consumption||Approx. 15 ～ 18m3/h||Approx. 18m3/h||Approx. 24m3/h|
|PCB||Width||50 ～ 250mm||50 ～ 400mm||50 ～ 500mm|
|Length||70 ～ 330mm||70 ～ 500mm||70 ～ 600mm|
|Component Height||Adjust height the labyrinth Upper/Lower 5 ～ 27mm（from chain top）|
|Flux Collection||Standard Equipment：Large-capacity flux collection unit by water-cooled.|